ufo

Lazar Sports Model

Physicist Bob Lazar worked at S4 near Area 51 back in the late 1980's on a back-engineering program that he claims began there in 1979. He says that an exchange program with the ETs occurred in the 1970's, which, resulted in the acquisition of nine UFOs so that their technologies could be researched.

The "Sport Model" is one of nine flying discs, at the S-4 facility. Some were recovered crashes and some were given to the American government in the early 1970's. The makers of the craft provided the fuel, Element 115, and are from the Zeta Reticuli Star System. A back enginerring program began in 1979 of the hardware and technology.

The saucer, Physicist Bob Lazar came into contact with while working at the S-4 facility near Area 51 in Nevada. He called the "Sport Model" the dimensions are 16 feet tall and 52 feet 9 inches in diameter. The exterior skin of the disc is metal and has a coloring similar to unpolished stainless steel. The craft sits on its belly when it is not energized. The entry hatch is located on the upper half of the disc with just the bottom portion of the door wrapping around the center lip of the disc.

Inside the Space Craft - The interior of the disc is divided into three levels. The lower level is where the three gravity amplifiers and their wave guides are located. These are the integral components of the propulsion system that are used to amplify and focus the gravity (A wave).

The Reactor is located directly above the three gravity amplifiers on the center level and is, in fact, centered between them. The reactor is a closed system which uses Element 115 as its fuel. Element 115 is also the source of the gravity A wave which is amplified for space-time distortion and travel. The Center level of the disc also houses the control consoles and seats, both of which were too small and too low to the floor to be functional for adult human beings. The walls of the center level are all divided into archways. At one point in time, when the disc was energized, one of the archways became transparent and you could see the area outside of it just as if the archway was a window.

When the operation of the disc was being demonstrated to Lazar, something incredible happened, of which, current technology could not produce. A form of writing, which was unlike any alphabetic, scientific, or mathematical symbols Lazar had ever seen, began to appear on the one side of the transparent archway. Lazar was never given access to the upper level of the disc. Therefore, Lazar was unable to provide any specifics as to what the porthole-like areas at the top of the disc actually were, but, most definitely, they are not portholes.

The Reactor - The power source is a reactor which uses Element 115 as its fuel. In this reactor Element 115 is used as a target and is bombarded with protons in a small, highly sophisticated, particle accelerator. When a proton fuses into the nucleus of an atom of Element 115, it is transmuted and becomes an atom of Element 116. Although we too can transmute elements here on earth, it is typically not done in this fashion, or at anywhere near this level of efficiency. As soon as each atom of Element 115 is transmuted into Element 116, Element 116 immediately decays and produces a radiation unlike that which we normally observe in nuclear decay. Each atom of Element 116 decays and releases two antiprotons (anti-hydrogen), a form of antimatter. Antimatter can be produced in particle accelerators here, but only in minute quantities and only stored for short periods of time. The flux of antimatter particles produced in the reactor are channeled down an evacuated, tuned tube (which keeps it from contacting with the matter that surrounds it) and reacted with a gaseous matter target. This Total Annihilation reaction is the most efficient and energetic nuclear reaction there is. The more familiar nuclear reaction are Fission, producing energy from the spitting of atoms as used in nuclear reactors and atomic bombs, and Fusion, the fussing or combining of atoms, typically fusing hydrogen nuclei to form helium and release even more energy. Fusion is the reaction that powers the sun and other stars and is what gives hydrogen bombs their "punch." These two more common nuclear reactions are dwarfed by the power and efficiency of the annihilation reaction used in the alien reactor. The reaction between the gaseous matter target and the antimatter particles produces a continuous release of tremendous amounts of heat. This heat is converted directly into electricity by the use of a thermionic generator. The thermionic generator used in this reactor is so efficient, that there is no detectable waste heat produced. This is an apparent violation of one of the basic laws of thermodynamics. Similar, but not nearly as efficient or powerful, thermionic generators are used as power sources in our satellites and space probes.

As amazing and efficient as all this seems, it is only secondary to the primary function of the reactor. The antiparticle flux emitted from the transmuting Element 115 is not the only energy radiated during operation. This is the point at which the gravity A wave is first produced. The gravity wave emitted by the Element 115 reaction appears on the hemisphere of the reactor, propagating up the tuned waveguides in a fashion very similar to the way microwaves behave. All of the actions and reactions inside the reactor are orchestrated perfectly like a tiny little ballet, and in this manner, the reactor provides an enormous amount of power used to amplify the gravity A wave so it can cause the requisite space-time distortion for space travel.

How the craft travels - The following is an analysis of the way some UFOs travel, an explanation of space-time manipulation by Bob Lazar.

"Assuming they're in space, they will focus the three gravity generators on the point they want to go to. Now, to give an analogy: If you take a thin rubber sheet, say, lay it on a table and put thumbtacks in each corner, then take a big stone and set it on one end of the rubber sheet and say that's your spacecraft, you pick out a point that you want to go to - which could be anywhere on the rubber sheet - pinch that point with your fingers and pull it all the way up to the craft. That's how it focuses and pulls that point to it. When you then shut off the gravity generators, the stone (or spacecraft) follows that stretched rubber back to its point. There's no linear travel through space; it actually bends space and time and follows space as it retracts. In the first mode of travel - around the surface of a planet - they essentially balance on the gravitational field that the gravity generators put out, and they can ride a "wave," like a cork does in the ocean. In that mode they're very unstable and are affected by the weather. In the other mode of travel- where they can travel vast distances- they can't really do that in a strong gravitational field like Earth, because to do that, first of all, they need to tilt on their side, usually out in space, then they can focus on the point they need to with the gravity generators and move on. If you can picture space as a fabric, and the speed of light is your limit, it'll take you so long, even at the speed of light, to get from point A to point B. You can't exceed it- not in this universe anyway. Should there be other parallel universes, maybe the laws are different, but anyone that's here has to abide by those rules."

Of Note - The Saucers in the Eduard 'Billy' Meier contact case in Switzerland that started in January of 1975 bear a striking likeness to the Sport Model in the Bob Lazar case.

These saucers are called Beamships. Listed is the technical information given by Billy on these ships.

Type 1 Beamship: Gave off radiation, drive system is light emitting device has two drive systems, one for planet travel, one for space travel.

Type 2 Beamship: Uses light in a highly concentrative manner.

Type 3 Beamship: Anti-Gravity drive system, two types, one for planet travel, one for space travel, planet drive based on principle of dischargement. Space drive is Tachyon drive.

Type 4 Beamship: Anti-matter drive (used now), ship weight 1.5 tons.

Technical information

Beam protection Girdle: Allows the atmosphere to glide away instead of pushing against the vehicle, in a sense diverting gravity.

Vehicle is seven meters in diameter and have a crew of three. When operating, the bottom of the ships are blue in color and seem to distort like a wash board. The energy of the vehicle goes out the bottom of the craft and is reclaimed at the top. Engines are an implosion device (matter is converted into energy). The antenna guide beam on top of the vehicles attract energies and can also detect energies. Inside of the vehicle has three seats which fold into sleeping couches. Most of the consoles of the vehicle are taken up with different kinds of screens: showing flight data, planet data, life form data, and psychic information of a life form. The windows of the craft control the ability to leave the ship. They read what atmosphere is outside the ship and change color. Orange on the outside and greenish yellow on the inside from earths atmosphere. They turn clear in outer space.

Metal used in the ship -Basically a copper-nickel-silver alloy.

Metal Making Process:

  1. Conversion from lead, collected from atmospheres of stars, from water, planets atmospheres and ores from star destructions.
  2. Assembled into soft metal lead, treated with chemicals to make it hard. Extracting all dangerous radiations.
  3. A heat process is used which converts the lead into an alloy.
  4. Other heat processes are also used, then water is used to cool the alloy.
Ships are assembled with a process similar to our welding but more sophisticated. The process liquefies the metal in a cold state and lets it flow into another, making it complete without suture forming one single piece.

Introduction The Book The Vacumm Explained Gravity Explained ARV Fluxliner Lazar Sports Models Links Contact Chris
©Copyright 2015 Christopher Bounds. All rights reserved. No portion of this website may be used or repoduced without permission.